GECAT 30

GECAT 30

Specifications

Center Cabin 9 meter (30Ft ) Walk-around

• Transom: Ultra Long 30 inches
• Inboard Fuel Tanks: ( 2 x 350 Lt S/S fuel Tanks) with gauges, sender and caps
• Buoyancy: Fully foamed
• 2 Anchor hatches with 316 Stainless steel hinges and catches
• 2 Storages Hatches with 316 Stainless steel hinges and catches
• 6 Cubby Holes in the inner skirt of the gunwales with S/S Hinges& catches (3 per side)
• Inserts in inner skirt for Gaffs and short rods (1 per side)
• Battery Boxes in the Gunwales (1 per side)
• Fuel Filter/Water trap hatch (1 per side)
• 1 Live Bait well in walkway between the motors pump supplied
• 1 Hydraylic ram access hatch in walk way
• 2 Deck wash points one forward and one Aft with pump hose and nozzel (salt water)
• Non- slip pattern on gunwales
• Gunwales reinforced below for rod holders Wakway between the motors
• 1 Fresh water shower at starboard rear corner of gunwale

Cabin

• Hatches/Seat in front of the cabin
• Steering console with large access hatch to area behind the console
• Head with electric toilet
• Hatches/Seat in front of the cabin
• Steering console with large access hatch to area behind the console
• 1 Head with electric toilet
• Fresh Water hand basin & Fresh Water Tank ( 60 litre)
• Marine toilet roll holder
• Toilet door with lock (removable) for easy access for maintenance on bilge pumps
• All skin fittings and Ball values are 316
• Trap door over step down to heads. This allows for someone to stand there when heads are not in use.
• One Electric and one manual Bilge pump in the heads
• Bench with drop down table which makes it a bunk or long bench seat this is on the port side.
• 12 Volt/220 Volt Fridge below the bench with drop down table on Portside and a set of draws
• Mounting point for Generater & Air Conditioning unit on roof of cabin
• Inside Finish in Cabin
• Cabin ceiling gelcoat finish
• Inside Panels in ripple gelcost finish

Windows. Windscreens, Hatches and doors

• 2 x Glass curved windscreens (Tinded if requires)
• 1 x Large sliding window on each side of cabin. (Tinted if required)
• 1 x Large Fixed window on each side of the cabin (Tinted if required)
• Centre screen with ventilation hatch (Tinted if required)
• 2 x Folding aluminum frame with glass doors at the back of the cabin
• Porthole in Heads

Deck

• 2 Anchor hatches with 316 Stainless steel hinges and catches
• 2 Storages Hatches with 316 Stainless steel hinges and catches
• 6 Cubby Holes in the inner skirt of the gunwales with S/S Hinges& catches
• 2 Inserts in inner skirt for Gaffs and short rods
• 2 Battery Boxes in the Gunwales
• 2 Fuel Filter/Water trap hatch
• 1 Live Bait well in walkway between the motors pump supplied
• 1 Hydraulic ram access hatch in walk way
• 2 Deck wash points one forward and one Aft with pump hose and nozzel (salt water)
• Non- slip pattern on gunwales
• Gunwales reinforced below for rod holders
• Walkway between the motors
• 1 Fresh water shower at starboard rear corner of gunwale

Seating arrangements:

• 1 on Skippers Chair Vetus Pilot Type
• 2/4 On drop down/removable table and seating on the Portside
• On bench seat on Starboard side behind the skipper chair with storage below
• Two/Three on Front of Cabin
• Two on Prepstation (Single Bench)

Upholstery:

• On all seats in cabin
• Skippers chair in same upholstery
• On rear prepstation
• On Front of Cabin

Deck Finish

• Non slip in fine grit
• Flotex carpet "Optional extra"
• Rubbing Strakes
• 3 Lights "All L.E.D. with Silicone wire & A.C Power Points
• 1 Port and Starboard navigation lights
• All round lights on small pole
• Red light over skippers position
• 2 White light in the ceiling opposite the skippers position and over the steps to the heads
• 2 Dome lights in the ceiling of the cabin
• 1 Lights in heads
• 2 Large dome lights under the rear overhang of the cabin (Rear deck lights)
• 2 9 gang switch panel
• 1 3 AC Power Pointsi in walkway & 2 in Cabin

Stainless Steel Fittings

• 1 Low profile arch for Antenna and lights
• 1 Bow roller/Anchor Roller
• 1 Anchor Bollard
• 1 Bow rails from Bow to front of cabin
• 6 Mooring cleats (3 per-side)
• 2 Grab rails on the top of the console over the heads
• 2 Trolling bars with G.R.P. moulded trolling boards and 6 rod holders
• 8 Rocket Launch/vertical rod holerss on back edge of the cabin
• 1 Walkway between the motors with drop down ladder
• 1 Bow eye
• 2 Stern eyes
• 8 Rod holders in the gunwale ( 4 per-side) Reinforced below