Gecat 21.6′
SPECIFICATIONS
Hull:
- 23 Ft ( Length 6,95 x Beam 2,75 meter) In colour of your choice
- Transom: XL (25 inch)
- Bulkheads 5 G.R.P Foamed in between
- 2 Inboard Fuel Tanks ( 100 Lt Roto Moulded) Cross linked Polyethylene
- Buoyancy: Fully Foamed
- Anchor hatches with 316 stainless steel hinges and catches
- Front Storage/ Hatch with 316 stainless steel hinges and catches
- 6 Cubby Holes in the inner skirt of the gunwales with S/S hinges & catches, 3 per side
- 2 Inserts for gaffs and spear guns, 1 per side
- 2 Battery Boxes in the gunwales, 1 per side
- 1 Live Bait well in walkway between the motors
- 1 Hydraylic ram access hatch in walk way
- 2 Deck wash points one Forward and one Aft with hose and nozzle
- 1 4,8 Bar Pump supplies water to the prep-station, live bait well and deck wash points. Salt water
- 1 Hatch/Seat in front of the cabin with 316 S/S hinges and catches
- 1 Steering Console with 1 set draws with moulded door & large access hatch to area behind the console
- Skippers resting post with seat behind insulated below as a cool box, 2 pax seats
- Smaller bum rest with seat behind on Port side, 2 pax seats
- Seating in fromt of cabin, 2 pax seats
- 2 Rear prep-stations
CABIN:
- Ceiling finish: Gelcoat Inside panels finish: Ripple gelcoat
- 2 Curved glass windscreens
- 1 Centre screen with ventilation hatch
- Ventilation Hatch in the ceiling “Optional”
- 2 Sliding window one on each side of the cabin
- 1 Rubbing Strakes: Black Aluminum
- 1 LED Port and Starboard navigation lights
- 1 LED All round on small pole
- 1 Red Light over skipper position
- 1 White Light opposite skipper
- 2 Large Dome Lights under overhang of the cabin (rear deck lights)
- 1 6 Gang switch panel
Deck Finish:
- Non-slip in Fine grit (Optional Extra” Flotex Carpet)
- Seats in Cabin and on rear prep station. (Optional Extra” on front of cabin)
- 2 x 200 Litre Fuel Tanks ” Stainless Steel Optional”
Stainless Steel Package:
- 1 Bow Rail from Bow to back of cabin
- 1 Bow roller/anchor roller
- 1 Anchor Bollard
- 1 Bow Eye
- 1 Stern eye
- 1 Walkway between the motors with dropdown ladder
- 1 Rocket launch/Vertical rod holders on back edge of the cabin
- 1 Trolling Bars with G.R.P. moulded trolling boards
- 6 Rod holders in the Gunwale (3 per-side) Reinfoced below
- 6 Rod holders on top of trolling boards (3 (per-side)
- 1 Low Profile Radar Arch/for antenna’s etc.,
- 6 Mooring Cleats
- 2 Grab handles
Steering System:
- Hydraulic hydrive cat mount with stainless steel steering wheel, heavy duty rose joints, and tie bar
Rigging of Motors:
- 4 x 80 Amp deep cycle batteries (2 for engines and 2 house batteries)
- 2 x Stainless Steel Transom plates
- Battery cabling and wiring
- 3 x Isolator switches
Electronic’s Garmin:
- 2 x 923XSV Plotter/Sounder
- 1 x VHF 215i AIS Radio with Antenna
- 1 x In hull GT 15M 600 watt Transducer
- 1 x Transom Mount Temp Prob
- Starter Kit